Wegener Communications 4422 - Manual (Page 47)

Page 47
Page 47 of 72 UTY4422-002
APPENDIX B
FRONT PANEL DISPLAY
B.1 HOME SCREEN
If there is no current alarm or warning condition, and the unit is NOT inserting, the following
home screen will be shown:
P O R T : x R A T E : y y . y y y
P R O G : z z z z z z z z z
PORT: x is the ASI input port, either 1 or 2
RATE: yyyyy.yy is the input data rate,
PROG: zzzzzz is the program number (up to 5 digits)
If alarm or warning condition is active:
A L A R M
m s g
or
W A R N I N G :
m s g
MSG: msg is a string identifying the condition. See Section 3.2 (Page 30) for warning and
alarm conditions.
If unit is inserting:
P O R T : x R A T E : y y . y y y
P R O G : z z z z z z z z z T E M P
PORT: x is the ASI input port,
RATE: yyyyy.yy is the input data rate,
PROG: zzzzzz is the program number (5 digits), and
TEMP: if this is output, the unit is inserting.
B.2 UNIT SERIAL NUMBER
To provide easy access to the unit’s serial number, press from the Home Screen to
display the serial number for approximately 2 seconds.