Wegener Communications 4422 - Manual (Page 39)

Page 39
Page 39 of 72 UTY4422-002
Table 20. LC Display Menus
Note: Screens marked by ‘*’ are not shown if local control is disabled (either programmed
into non-volatile memory at factory or set by COMPEL command). Exception: “Audio
Settings” screen is shown but only “Attenuation” may be changed by local user.
MAIN LEVEL SECOND LEVEL THIRD LEVEL
Home Screen N/A N/A
EMAIL Email Msg
Hardware Setup Current Settings* ASI port, Data-rate and Program #
Select Channel*
Edit Channel*
For each possible channel entry...
ASI port, Data-rate and Program #
Aspect Ratio Mode* 4:3, 16:9, or Auto
Audio Settings* For each port: Route:, Lang: (Program), and Atten:
Select Serial1: Aux Data, Modem, Term., or Printer
Select Serial2: Aux Data, Modem, Term., or Printer
Modem Password: 6 alphanumeric char’s max. Default
is ‘PASSWD’
Printer Settings: Baud, Parity
Modem Settings: Baud, Parity
Serial Ports (Both Ports
MUST not be set to the
same device at the same
time. Modem and
Terminal may not be
selected at the same time.)
Aux Data Settings: PID , Baud, Parity
Test Mode For Factory Use
LNB DC Power ON or OFF
Unit Reset
Settings Status
PERM, TEMP, or SEARCH settings Status Reports
ASI Input Status (Locked) Acq. Mode / Mode Duration
ASI Port, Data Rate, Program #
Number Input Errors, Availability
Last Acq., First Acq.
ASI Input Status (Not
Locked) Acq. Mode / Mode Duration
ASI Port, Data Rate, Program #
ASI Rx Error
No MPEG, Wrong Header
MPEG Status Aggregate MPEG Transport Rate
Program Presence
Video muting
Aspect Ratio
Audio Presence
(Audio) Port 1 Program, Routing, Muted/Unmuted
(Audio) Port 2 Program, Routing, Muted/Unmuted
Table 20. LC Display Menus (Continued)