Wegener Communications 4422 - Manual (Page 35)

Page 35
Page 35 of 72 UTY4422-002
control source, the specified configuration is immediately stored for the specified device. The
serial port is configured accordingly, whenever the serial_port.device is device when local panel
control has been enabled by the satellite program provider. If serial_port.device is device at the
time this command is issued, and the configuration differs from the current configuration, the
output_buffer is cleared and the port is reconfigured.
When connected to a Terminal, the port may also be configured for baud rate, etc. Care should
be taken when changing these settings so they agree with the internal terminal settings. If you
change the baud rate of the Terminal Port to 9600, you will have to change the terminal baud
rate to 9600 before you can communicate through the Terminal Port.
The following table specifies which outputs are routed to which device for each of the valid
device combinations.
Table 15. Serial Port Operation
Serial1 / Serial2 Output (Type of Data) Port Data Sent To & Conditions
Printer / Terminal COMPEL Email To printer if COMPEL_email is
detected & raw data is not being
processed.
COMPEL Requested
Reports To printer if raw data is not being
processed.
Raw Uplink Data. To printer if raw data is being
processed.
Printer / Modem COMPEL Email Same as for printer / terminal.
COMPEL Requested
Reports Same as for printer / terminal.
Raw Uplink Data Same as for printer / terminal.
3.8 RECEIVER FUNCTIONS
3.8.1 Perms, Temps, Searching & Settings
The term settings is used throughout this document and includes the parameters in Table 16
(Page 36).