VBrick Systems 7000 - Manual (Page 34)

28 © 2009 VBrick Systems, Inc.
SNMPv3 Passwords
Use this page to manage SNMP passwords. The same fields are used to define passwords for
all users.
DTR Control Force OFF, Force ON or Automatic. If automatic, the control will
be ON when Passthrough is active. See note above.
COM Interface Type Describes the COM interface connector.
• RS232 – standard RS-232 serial port connector.
• RS422/485 – RS-422/485 4-wire serial port connector.
Operational State Describes the current status of a Passthrough connection,
including error conditions, if any. Refer to the Monitor > Network
page. This will display "Active" if in Passthrough mode.
User Name Read-only. Set user name on Usernames & Passwords page.
Authentication Password Enter password. Cannot exceed 20 characters. May include any
combination of alphanumeric characters but only the following
special characters:
~ ! # $ ^ * + & [ ] { } | < > See Table 2 for
defaults.
Authentication Protocol Select protocol: HMAC-MD5 or HMAC-SHA.
Privacy Password Required.
Security Level No Authentication, No Privacy (Default).
Authentication. No Privacy.
Authentication and Privacy (CBC-DES)