VBrick Systems 7000 - Manual (Page 25)

System Configuration
VBrick H.264 Appliance Admin Guide 19
Security
IP Address Defines the Destination IP Address for Management SAPs.
Port Defines the Destination Port for Management SAPs.
Note If you disable Telnet, FTP, VBAdmin, the Front Panel, and SNMP, the only way to
manage (and re-enable) these parameters is to connect a PC to the appliance with a
serial cable and use the Command Line Interface. You should never disable all the
network management interfaces if you are using the COM port for serial passthrough.
External Telnet Server Default = Enabled. Disabled will prevent Telnet sessions to the
VBrick appliance.
External FTP Server Default = Enabled. Disabled will prevent FTP sessions to the
VBrick appliance. Note that this feature must be enabled to
upgrade the appliance firmware using VBDownload.
External VBAdmin Default = Enabled. Disabled will prevent you from managing the
VBrick from a web browser using the VBAdmin application.
External SNMP Default = Enabled. Disabled will prevent you from using an
external MIB browser to view or write parameters.
External SNMPv1
and SNMPv2 Access Default = Enabled. You can use both SNMP v1/v2, and v3. For
tightest security, set parameter to Disabled and use SNMPv3 only.