Verizon DMS 100 - Manual (Page 19)

35
Call Park
Call Park functions like Call Pick-Up except that the call is already in
progress. You can “park” an established call on your line against your
own number, freeing up your line to place or receive another call.
The parked call can be retrieved from any other station within the
CustoPAK system, including your own. Only one call can be parked
against a CustoPAK line at a given time. This feature is not avail-
able in the DMS 10 switch type.
To “park” a call against your number:
Ī
Tell the person to whom you are speaking that you are going to put
them on hold.
Ī
Press the switchhook (or the Tap/Flash/Recall/Link button,
depending on your telephone set).
Ī
Press and listen for confirmation tone.
Ī
Hang-up.
To retrieve a call you “parked” against your number:
Ī
Lift the handset and listen for dial tone.
Ī
Press and listen for confirmation tone.
Ī
Begin your conversation.
NOTES:
1.) If a parked call is not retrieved, the parking station will be
recalled when idle.
2.) A station in the “call parked” condition cannot use the Three-Way
Calling feature.
3.) Call Waiting will not activate against a number in a “parked”
condition.
34
4.) When your phone rings with a short-short-long ring, you need to
answer by the third series of rings or Busy Redial will pause and
try to complete your call 5 minutes later.
5.) Busy Redial and Automatic Callback cannot be on the same line.
6.) This feature must be applied to all members of a Hunt group.
7.) Busy Redial will not activate a Call Waiting tone.
Call Block (*60)
Call Block provides you with the capability to block up to 12 external
telephone numbers (within your regional calling area) from calling
your number, preventing unwanted and nuisance calls. Once activat-
ed, any calls from these 12 numbers will be routed to an intercept
message. For your protection, calls from outside of your regional
calling area and operator-handled calls cannot be blocked.
This feature is not available in the DMS 10 switch type.
To access the Call Block feature:
Ī
Lift the handset and listen for dial tone.
Ī
Press .
Ī
Listen to the voice-recorded instructions for Call Block options.
GTD-5 switch type only:
If you are a member of a Hunt group, you must:
Ī
Lift the handset and listen for dial tone.
Ī
Press .
Ī
Listen to the voice-recorded instructions for Call Block options.
NOTES:
1.) Blocked calls will not be forwarded on any Call Forwarding
arrangement and will not appear on Caller ID displays.
2.) Call Block takes precedence over Series Hunting.
3.) This feature must be applied to all members of a Hunt group.