Visioneer XP 100 - Manual (Page 147)

140 V ISIONEER S TROBE XP S CANNER U SER ’ S G UIDE
Maintenance
This chapter contains information on recalibrating, troubleshooting,
cleaning, uninstalling, and scanner specifications.
R
ECALIBRATING OR
C
LEANING
Y
OUR
S
CANNER
You calibrated your scanner during installation, but after many hours of
use you may find that scanned images may not be a sharp and clear as
when you began using the scanner. In that case, recalibration may solve
the problem.
If your scanned images have streaks, smudges, or dirt spots, you may
need to clean the scanner with the Cleaning Paper.
To recalibrate your scanner:
1. Strobe XP 300 only: Close the scanner’s paper return so the
calibration paper will feed straight through the scanner.
Strobe XP 200 only: Move the scanner’s Paper Return into the Up
position so the calibration paper will feed straight through the
scanner.