beautypg.com

Troubleshooting, Osd message – VIEWSONIC PJ750 User Manual

Page 22

background image

20

ViewSonic PJ750

TROUBLESHOOTING

OSD Message

The messages as described below may appear on the screen at power ON. Take the appropriate mea-
sures when such messages appear.

Table 9: OSD Message

NOTE:

(*1) This message is cleared automatically after approximately three minutes, and appears every

time power is switched ON.

(*2) The unit has a function to turn the power off which will be active when the usage time reaches

2000 hr. However the life of lamp might be much different among lamps, so that it might happen that

a lamp is cut off before the function is active.

Message

Contents

CHANGE THE LAMP

AFTER REPLACING LAMP,

RESET THE LAMP TIME.

(*

1)

The usage time of lamp will be reaching 2000 hr shortly (*2).
It is recommended to replace the lamp soon. Prepare a new
lamp as replacement.

CHANGE THE LAMP

AFTER REPLACING LAMP,

RESET THE LAMP TIME.

THE POWER WILL TURN OFF

AFTER **hr.

(*

1)

The usage time of lamp will be reaching 2000 hr shortly.
It is recommended to replace the lamp within * * hours (*2).
It might happen that the lamp is cut off before * * hr by any
chance. Power will be switched OFF automatically in * *
hours. Replace the lamp as shown on p. 17-18, “Lamp.”
Always reset the lamp timer after replacing the lamp.

CHANGE THE LAMP

AFTER REPLACING LAMP,

RESET THE LAMP TIME.

THE POWER WILL

TURN OFF

AFTER 0 hr.

The usage time of lamp is about to reach. Power will be
switched OFF in a few minutes (*2).
Switch power OFF immediately and replace the lamp as
shown on p. 17-18, “Lamp.” Always reset the lamp timer after
replacing the lamp.

NO INPUT IS DETECTED

ON ***

No input signal found.
Check the signal input connections and signal sources.

SYNC IS OUT OF RANGE

ON ***

The horizontal or vertical frequency of the input signal is not
within the specified range.
Check the specifications of the equipment and the signal
source.