Uniden D2998-6 - Manual (Page 5)

English - 5
Set Up the Accessory Handset(s)
Install and Charge the Battery
1. Unpackallhandsets,batterypacks,andbatterycovers.
Ifanyhandsethasthebatterycoveralreadyattached,
pressinonthenotchandslidethecoverdownand
off.
2. Lineupthebatterypackconnectorwith
thejackinsidethehandset.(Thebattery
connectorwillonlyfitoneway.)
3. Pushthebatterypackconnectorinuntilit
clicksintoplace.Tuggentlyonthewirestomakesurethebatterypackis
securelyconnected.
4. Placethebattercoverandslideitupintoplace.
5. UseanACadaptertoconnectthepowerjackoneachchargertoaregular
indoor(120VAC)poweroutlet.
6. Placeeachhandsetinachargerwiththedisplayfacingforward.Ifthe
chargE lightonthechargerdoesn’tlightup,reseatthehandsetorconnect
thechargertoadifferentoutlet.
# Charge all handsets completely (about 15 hours) before using them.
Test the Connection
Pickupeachhandsetandpress talk/enD.Youshouldhearadialtone,andthe
displayshouldsay Talk .(Press talk/enDagaintohangup.)
Ifthereisnoiseorstatic,seep.22fortipsonavoidinginterference.