Uniden D2998-6 - Manual (Page 24)

24 - English
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter and
phone cord from the wall before touching it.
Iftheliquidisonlyontheexteriorhousingofthebaseorhandset,wipeitoff
anduseasnormal.Ifyoucanhearliquidinsidethehousing:
1. Disconnectallcablesandcordsandremoveallcompartmentcovers.
2. Ifliquidisleakingfromanyventorhole,turnthephonesothatventfaces
down.Ifnot,placethelargestventfacedown.
3. Letdryforatleast3days.Checkforliquidinsidethephonebeforereplacing
compartmentcoversandreconnectingcords.
Resetting Stations
Ifyouhaveproblemswiththebase,unplugthebasetoresetit.Plugitbackin
afteratleastaminute.
Ifyouhavetroublewithacordlesshandsetorifyouwanttoreplaceone,reset
it:
1. Pressandhold
flash/exitandpOunD (#) atthesametimeuntil System Reset 
displays(about5seconds).
2. Ifyoustillhavethebasethehandsetisregisteredto,select Deregister HS ,then
selectthehandsetyouwanttoreset.Ifyoudon'thavethatbaseanymore,
select Base Unavailable .
3. Toconfirm,select Yes .Thehandsetdisplays Handset not registered .
Registering a Handset
Ifyouseea“notregistered”messageonahandset,youmustregisterittoa
basebeforeusingit.
1. Onthebase,openthemenuandselect
Register Handset .
2. Onthehandset,pressandhold pOunD (#) untilthehandsetdisplaysays
Handset Registering (about2seconds).
3. Waituntilthehandsetdisplaysays Registration Complete (about30seconds),
thenpickupthehandsetandpress talk/enD.
#
If you don’t hear a dial tone or the display says Registration Failed , charge
the battery completely, then try again.