beautypg.com

Uniden UBC785XLT User Manual

Page 49

background image

45

Reverse Mode

This key will allow you to observe the reverse frequency of the repeater. While pressing
RVRS, the standard pair frequency will be displayed. For a list of the standard pair
frequencies, refer to the table "Reverse List" in the Appendix. If the frequency that you have
chosen does not have an offset frequency, the display will indicate

ERROR and NO

REVERSE.

Channel Step Selection

You can set frequency step, 5 kHz - 100 kHz or Auto in Chain search frequency. The default
receive mode should be the proper mode setting in almost all cases. You may wish to set
some VHF channels for NFM mode, depending on any adjacent channel interference
problems. WFM is typically only used for broadcast frequencies, such as TV audio or FM
radio.

See

STEPS in "Menu Description" for details.

Mute On/Off

To manually turn ON the Mute function, press and hold MUTE until

MUTE ON is displayed.

You will not hear any audio. To turn it OFF, press and hold MUTE again.

Receiving Mode Selection

You can also set the receiving mode, AM or NFM in Chain Search mode.

See

MODE in "Menu Description" for details.

Frequency and Channel Tuning with the VFO Control

The VFO knob can be used for stepping frequencies or through memory channels.

To switch the setting for the VFO control, press the VFO. This will change modes from
Channel to Frequency or Frequency to Channel.

1. In scan hold mode, when the setting for the VFO is channel, rotate the VFO to move up

(to step up through channels) or down (to step down through channels).

2. In Chain Search mode, when the setting for the VFO is frequency, rotate the VFO to move up

to step up through frequencies sequentially or to down to step down through frequencies. To
change the step, you will need to go into the Chain Search menu and adjust the step for the
desired memory location.

☞ Remember! When you set Additional Features through the menu screen, you can also

use

▲ or ▼ instead of rotating the VFO.

Also instead of pressing E, you can press the VFO control.

UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 45