Uniden UBC785XLT - Manual (Page 25)

Note: Through the System Menu you can set the radio to operate in Tone
Search mode during Search as well. In this mode, the radio will
automatically determine the active subaudible tone on any frequency
received during the search.
6:RECORD
With this feature set to on, any frequency that is active during the search, can
be recorded to an external tape recorder.
7:AUTO STORE
You can automatically store the active frequencies found during a search into
the memory. You can select the bank to program. The audio will be muted.
2:SCAN OPTION
1:FREQUENCY
Allows you to program a frequency to a memory channel or edit the frequencyl
already programmed. You can also set an alphanumeric text tag (alpha tag) for each
programmed frequencies.
2:DELAY
You can set delay for the memory channel. The default delay is two seconds.
3:TONE DATA
You can set a CTCSS (analog) or DCS (digital) subaudible tone for a frequency. To
do so you must have the SQ Mode in the System Menu set to Tone SQ. You can
also program a subaudible tone easily by pressing the E key in Scan Hold mode after
programming a frequency. This will bring up the Tone Data menu without having to
navigate the Menu. By doing this you will receive all transmissions on the frequency,
regardless of the subaudible tone, except the one which you have locked. Any
transmissions with that tone will not be received.
4:BEEP ALERT
You can set a Beep Alert per channel to alert you when specific frequencies are
active. For example, you may wish to be alerted anytime a mutual aid fire frequency
is active. With Beep Alert, you will hear three beeps at the start of each transmission
that you have flagged as such. You will also notice that as you scroll pass the flagged
channel(s), you will hear three beeps.
5:ATTENUATOR
See
1: SEARCH OPTION/ 2:CHAIN SERACH/ 4:ATTENUATOR.
6:STEPS
Your UBCD785D is programmed with default step sizes for each frequency range
(see page 1). Steps are important if you are interested in using the VFO to tune off
from a frequency programmed into memory or if you wish to program a frequency
that the default step size will not accept.
7:MODE
Default Auto receive modes are also programmed into memory. AM for aircraft for
example. You can change the default settings on a per-channel basis with this Menu
item.
21
UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 21