Uniden UBC785XLT - Manual (Page 26)

8:RECORD
You can flag any channel for recording using this menu function. Use your own
recording device plugged into the jack on the back of the scanner.
3:SYSTEM OPTION
1:DIMMER
Allows you to change the brightness of the display.
2:SCREEN MASK
Screen Mask allows you to limit what appears on the display to the alpha tags that
you have set for a channel along with a few function icons. Screen Mask removes the
frequency, receiving mode tone data and signal strength bars. This mode is
particularly useful in public safety vehicles where "information overload" is already a
problem. Screen Mask does not work in Search mode.
3:KEY BEEP
Use this function to turn
OFF the keypad acknowledgement beep. The default setting
is ON.
4:ENTER LOCK
Use Enter Lock to prevent accidental re-programming of channels, tone
(CTCSS/DCS) and talk groups entered into memory. The default setting is
OFF.
5:PC CONTROL
Use this function to set the transfer speed (baud rate) at which your personal
computer (PC) communicates with the scanner when downloading information into
your scanner using Uniden E-Scanner software. See page 40 for details.
6:CLONE
You can clone all the programming, including frequencies and alpha tags as well as
bank settings and other parameters from another UBC785XLT.
7:DATA SKIP
A scanner will normally stop on any transmission it receives. This means the
UBCD785D will occasionally stop on data signals and unmodulated transmissions.
You can automatically skip many of these types of transmissions during search.
8:SQ MODE
The SQ Mode allows you to set at your option, whether the scanner will stop on all
active transmissions on a particular frequency or it will only respond to transmissions
with a pre-set subaudible tone. This applies to both Conventional Search and Scan
modes. The options are as follows:
22
UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 22