beautypg.com

Starting the bios setup program, Modifying the bios – Toshiba M400 User Manual

Page 264

background image

G-4

User’s Manual

TOSHIBA RAID

Starting, Modifying and Ending the BIOS Setup

Program

Starting the BIOS Setup Program

1. Turn on your computer while pressing the Esc key.

If Password = is displayed, enter the User Password and press the
Enter key.
Please refer to Chapter 6, the

TOSHIBA Password Utility

, for details

about the User Password.
The "Check system. Then press [F1] key." message is
displayed.

2. Press the F1 key.

The BIOS setup program will start up.

Modifying the BIOS

1. Select the RAID ARRAY setting in the SYSTEM SETUP (3/3) screen.

2. The settings are explained as follows. Modify the settings as necessary.

Configuration status and settings

Please refer to the operating instructions displayed in the settings screen.

Current State

Shows the current hard disk status.

Create State

Modify the hard disk configuration. (Modifications
are made with this setting).

Built-in HDD

Status of the connected hard disk.

Second HDD

Status of the second hard disk.

JBOD

No RAID settings. Windows cannot be installed
in this disk except for using recovery CD/DVD.

1RAID-0

Including RAID settings. Windows can be
installed in this disk.

2RAID-0

Set to RAID-0 for 2 hard disks. This cannot be
set in this computer (Current State Only).

RAID-1

Set to RAID-1 for 2 hard disks (Current State
Only).

UNKNOWN

A RAID status except for the above status and
settings (Current State Only).

No Drive

No hard disks connected (Current State Only).