Installing memory module, Installing memory module -10 – Toshiba M400 User Manual
Page 186
8-10
User’s Manual
Optional Devices
Installing memory module
There are slots for two memory modules. The procedures are the same for
installing either module.
1. Set the computer to boot mode and turn the computer’s power off.
Make sure the Power indicator is off.
Refer to the
section in Chapter 3, Getting Started.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
section in Chapter 6, Power and Power-Up
Modes, for details.
4. Turn your computer over.
5. Push the display latch on the front of the computer and open the LCD
display panel.
6. Slip your finger under a notch at the end of the keyboard brace and lift
up to release latches and remove the keyboard brace.
Figure 8-7 Removing the keyboard brace
7. Remove two screws securing the keyboard.
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.
Keyboard brace
Use a point size 1 Phillips screwdriver.