beautypg.com

Installing the hdd kit (serial-ata), Installing the hdd kit (serial-ata) -18 – Toshiba M400 User Manual

Page 194

background image

8-18

User’s Manual

Optional Devices

5. A small row of ridges marks the latches securing the cover. Press on

these ridges until you hear a click.

6. Press on the arrows and lift the cover up and out to remove it.

Figure 8-18 Removing the hard disk drive cover

7. Reposition the hard disk drive until it is vertical.

8. With the hard disk drive in a vertical position, lift it straight up and away

from the connector.

Figure 8-19 Removing the hard disk drive pack

Installing the HDD Kit (Serial-ATA)

To install the HDD Kit (Serial-ATA), follow the steps below.

1. Move the connector until it is vertical.

2. Hold the hard disk drive vertically with its label on the left.

3. Connect the hard disk drive to the connector.

Screws

Hard disk drive
cover

Plastic tab

Hard disk drive
pack

Connector

Ensure that the hard disk drive is connected to the connector in a vertical
position. If the hard disk drive is slanted and connected to the connector, it
might damage the connector.