beautypg.com

Direct station selection (dss), Tone/pulse dialing – Toshiba Strata DK User Manual

Page 53

background image

Features

Direct Station Selection (DSS)

Strata DK Electronic Telephone 5/00

41

Direct Station Selection (DSS)

This optional feature enables you to use a

'66

button to connect directly to another

station. The LED of the button shows the status (idle/busy) of the station and/or the
station’s [PDN].

For example, a station DSS LED shows busy (light steady red) when the station is:

Busy on a call on any button or is in the DND mode.

Idle, but all appearances of the [PDN] are in use by other stations.

To connect directly to another station [PDN]

2. Dial a CO Line or CO

Line access code
when you hear dial
tone

If you do not hear dial tone, you must also dial a DISA
security code. See

Table 7 on Page 64

.

...or dial a CO Line
or CO Line access
code and then a
DISA security code.

You hear dial tone.

Note

See the System Administrator for the DISA
security code number. If the correct code is
not entered, the call disconnects.

3. Dial a telephone

number.

If set in system programming, both parties hear a
warning tone approximately 4, 10, or 20 minutes after
the call was made. Press

to reset the timer each time

the tone sounds (for an additional 4, 10, or 20
minutes). If you do not press

, the call disconnects

approximately one minute after the tone.

1. Press

'66

, while

connected to a CO
Line or another
station.

The original party is put on hold. You can call a station
even if the DSS LED shows busy (steady red).