Thecus Technology N299 - Manual (Page 30)

LAN Configuration
The N299 supports a second
Ethernet port for higher service
availability. To configure these ports,
choose LAN from the Network
menu, and the LAN Configuration
screen appears. Press Apply to save
your changes.
LAN Configuration
Item Description
MAC Address
Displays the MAC address of the LAN interface.
Jumbo Frame Support Enable or disable Jumbo Frame Support on the LAN interface.
IP Specifies the IP address of the LAN interface.
Netmask Specifies the Network Mask of the LAN interface.
DHCP Server Configuration
Item Description
DHCP Server
Enable or disable the DHCP server to automatically assign IP
addresses to PCs connected to the LAN interface. Default is
Disabled.
Start IP Specifies the starting IP address of the DHCP range.
End IP Specifies the ending IP address of the DHCP range.
DNS Server Specifies the DNS server IP address.
Apply Click Apply to save your changes.
Cancel Click Cancel to abandon your changes.
DN
T S
• Before enabling Jumbo Frame Support, please make sure your network
equipment supports Jumbo Frame. If your equipment is incompatible, you might
not be able to connect to your N299. In this case, you have to reset the system
back to default by the holding down rear panel reset button for 15 seconds
during boot up process.
• The IP Segment of WAN and LAN should not overlap.
NOTE
WARNING
The IP address of the LAN interface should not be in the range of the Start IP
address and End IP address.
D S Configuration
atures S support. To configure DDNS, choose DDN
from the Network men
he N299 also fe Dynamic DN
u. Press Apply to confirm your settings.
DDNS Support
Item Description
Register Support
www.dyndns.org , www.zoneedit.com , www.tzo.com
User Name S domain. Input user name that you have register in DDN
Password n. Input password that you have register in DDNS domai
Domain Name Input registered domain name.
Apply Click Apply to save your changes.
Cancel Input Click Cancel to abandon your changes.
30