Thecus Technology N299 - Manual (Page 10)

Front Panel
The N299’s front panel displays the unit’s array of status LEDs, and is also where
you’ll find the power button and USB port. See the table below for a detailed
explanation of each:
Item Description
Power LED
• Solid blue: N299 is powered on
System Status LED • Blinking orange: system is starting up
• Blinking red: system error
• Off: system startup complete; system operating normally
HDD1 LED • Solid blue: HDD 1 detected
• Blinking blue: Active HDD 1 data transfer
• Solid red : HDD 1 error detected
• Blinking red: HDD 1 capacity is nearly full (90% or more)
* If RAID is configured, capacity is based on the entire RAID
system.
HDD2 LED • Solid blue: HDD 2 detected
• Blinking blue: Active HDD 2 data transfer
• Solid red : HDD 2 error detected
• Blinking red: HDD 2 capacity is nearly full (90% or more)
* If RAID is configured, capacity is based on the entire RAID
system.
One-Button USB
Copy
• One-Button Copy
Push once to copy entire USB volume to the N299. A short
beep will sound to acknowledge that files are now being
copied. Files are stored in a folder named by current time
stamp: (YearMonthDayHHMM)
WAN LED • Solid green: network link
• Blinking green: network activity
LAN LED • Solid green: network link
• Blinking green: network activity
USB LED • USB Device Connection
o
Blinking blue (5 seconds): USB device connected
successfully.
*For universal USB memory card readers, the USB LED
will blink blue when one or more card is mounted
successfully.
10