Olympus SZX10 - Manual (Page 24)

20
}When using the micrometer eyepiece disk, insert it in the right eyepiece.
(It may be inserted in the left eyepiece but the description in this manual
assumes that it is inserted in the right eyepiece.)
1. Remove the eyepiece dust caps @ and loosen the eyepiece clamping
screws ² completely.
2. Gently insert the eyepieces of the same magnification ³ into the left and
right eyepiece sleeves all the way until they stop.
3. Tighten both eyepiece clamping screws ².
Place the stage plate into the mounting hole on the base.
To remove, press the stage plate at the edge nearest to the pillar with
your fingertip. The opposite end will rise from the base so the stage plate
can be picked up easily.
8 Mounting the Specimen Holder (Fig. 23)
}Use the specimen holder when you want to hold the specimen so that
it will not move.
Insert the specimen holder @ into the two holes ² on the top surface of
the base.
Loosen the focusing assembly clamping knob @ Slightly pivoting the
microscope body to the left and right, align the center of the objective
with the center of the stage plate ², then clamp the microscope body
with the focusing assembly clamping knob.
Fig. 21
@
²
³
6 Mounting the Eyepiece (Fig. 21)
Fig. 22
Fig. 23
Fig. 24
@
²
7 Mounting (Removing) the Stage Plate (Fig. 22)
9 Positioning the Microscope Body on the Stand (Fig. 24)
@
²