Toshiba PERCEPTION 4000 - Manual (Page 30)

To Enter an Authorization Code
from an Idle Station:
1. Take the station off-hook.
2. Press the Authorization Code
(AUTH) access key or enter
the Authorization Code
access code.
3. Enter the desired authorization
code.
4. Dial the destination call
number or enter the desired
feature access code.
To Enter an Authorization Code
from a Station Involved in a Call:
1. Press the CONF/TRNS key.
2. Press the AUTH key or enter
the Authorization Code
access code.
3. Enter the desired authorization
code.
attendant console will indicate the number of the calling station. The
number will remain displayed until the call is disconnected from the
console.
AUTHORIZATION CODE ENTRY
You can access features that are normally restricted at a station, by
entering a specific authorization code. All call allowances that are
associated with the entered code will be allowed on the line used to
place the call. This allows you to place certain types of calls from any
station in the PERCEPTION 4000 system, regardless of the station’s
individual restrictions. The call allowances will remain in effect for the
duration of the call, after which the station’s original calling restrictions
will be restored. Authorization codes can be entered from either an idle
station or a station involved in a call.
Listen for dial tone.
Listen for recall dial tone. Display telephones will display “AUTH CODE.”
Listen for dial tone. If an invalid authorization code is entered, dial tone
will sound, but the station’s original calling restrictions will not be altered.
The entered authorization code will be applied to the dialed number or
feature.
Your current caller will be placed on “soft hold.” Listen for recall dial tone.
Listen for recall dial tone.
Listen for dial tone. If an invalid authorization code is entered, dial tone
will sound, but the station’s original calling restrictions will not be altered.
PERCEPTION 4000 FEATURE OPERATION
4-4