beautypg.com

4 • advanced operations—voice reduce function, 11 voice reduce function, 12 programmed playback – Tascam CD-302 User Manual

Page 26

background image

4 • Advanced Operations—Voice Reduce function

26

TASCAM CD-302

1

Press the

PRESET

key.

2

Select

09 SAMP/R

(

SAMP_R

) using the dial or

numeric keys.

3

Press the

ENTER

key.

4

Select

On

or

Off

using the dial.

5

Press the

ENTER

key.

However, even if the sampling point recall is set to
off, memorized sample data can still be loaded later:

1

Recall the memory (see 4.10.2, “Recalling a
memory”). If sample points have been stored
in the memory, the

IN

and

OUT

keys will flash

three times.

2

Pause playback.

3

Press and hold the

OUT

key for more than two

seconds.

The sample data are loaded, and the

IN

and

OUT

keys will light.

4.10.6 Clearing memories

It is possible to clear all memories together, or clear
them individually.

To clear individual memories:

1

Recall the memory.

2

M

will show on the display.

3

Press and hold the

MEMORY

key

J

for two

seconds or longer.

4

The

M

in the display will go out.

To clear all memories.

1

Press the

PRESET

key.

2

Select

24 ALL/CL

(

ALL_CL

)

using the dial or

numeric keys.

3

Press the

ENTER

key. The display will show

-SuRE-

(

-SURE-

).

4

Press the

ENTER

key to confirm the deletion of

all memories.

NOTE

If you are clearing all memories and then turning off
the power, wait a few seconds between pressing the
ENTER key and turning off the power.

4.11 Voice Reduce function

This function lowers the volume of the vocal part of
the material being played back when enabled. Note
that this may work better on some recordings than
others.

1

Press the

PRESET

key.

2

Select

10 VOICE/R

(

VOICE_R

) using the dial

or numeric keys.

3

Press the

ENTER

key.

4

Select

On

or

Off

using the dial.

5

Press the

ENTER

key to confirm this setting.

4.12 Programmed playback

Add up to 30 tracks to a program for programmed
playback in a series of program steps.

Even when the power is turned off, if you have set a
programmed playback order set and enabled timer
play, programmed playback will start when the unit
is turned on, as the program is stored in memory.

4.12.1 Setting the program steps

This adds tracks as program steps in a new program.

1

Press the

PRESET

key.

2

Select

11 PROG

(

PROG

) using the dial or

numeric keys.

3

Press the

ENTER

key. The program step num-

ber and the track number are shown on the
display.

4

Use the

SKIP

keys

C

to select the track to be

played as the currently-shown program step.

5

Press the

ENTER

key to confirm the entry.

6

Repeat 4 and 5 above for as many steps as will
be entered into the program.

7

To finish the program entry sequence, press
the

PRESET

or

ENTER

key (or any key except

the

SKIP

keys).

4.12.2 Adding tracks to the middle of a

program

When you have created a program, you can insert
tracks as new program steps part of the way through
the program.

1

Press the

PRESET

key.