Tascam CD-302 - Manual (Page 15)

2 • Front and rear panels—Display
TASCAM CD-302
15
2.5 Display
Each unit is fitted with a display, providing the fol-
lowing information:
c TRACK indicator
Shows the current track.
d Bank indicators
Show the current memory bank.
e Loop mode indicator
Displays current loop mode ( A-B , ALL , SINGLE ) and
loop mode on/off.
f REMAIN indicator
Lights when the “remain” display mode is selected.
g M (memory) indicator
Used to show memory settings.
h SINGLE indicator
Lights when the single track playback mode is
selected.
i PROGRAM indicator
Lights when programmed playback is selected.
j Time display
This part of the display is used to show time values
or messages.
k Time address bar
This part of the display gives a “bargraph” indication
of the current playback position relative to the cur-
rent track.
The indicator segments light from left to right when
elapsed time mode is selected.
When remaining time mode is selected, indicators go
out from left to right.
If an EOM (End of Message) time has been set, the
bottom bar and the remaining segments will blink
when the EOM time is reached.
l TEMPO indicator
Displays the current tempo setting (playback speed).
m KEY indicator
Displays the current key setting (the total of the key
setting and the value set by the slider).
n INDEX indicator
Lights when the index search mode is enabled (see
A
).
o INCR indicator
Lights when the Incremental Play is enabled (see
4.18, “Incremental Play”).
p AUTO READY Indicator
Lights when the Auto Ready mode is enabled (see
4.16, “Auto Ready”).
q RELAY Indicator
Indicates when the Relay Play mode is enabled (see
4.19, “Relay Play”). This mode is automatically
enabled for both decks when it is enabled on one
deck.
r AUTO CUE Indicator
Lights when the Auto Cue mode is enabled (see
3.3.2, “Auto Cue”).
, .
/
! @ # $ %
^
&
* (
) Q
W E