Tascam CD-302 - Manual (Page 13)

2 • Front and rear panels—Remote control unit (front panel)
TASCAM CD-302
13
D CUE key
If a cue point has been stored, the unit will play when
the
CUE key is pressed, and enter pause mode when
this key is released.
E PLAY/PAUSE key
Changes between playback and pause mode.
The key lights steadily in playback mode, and flashes
in pause mode.
If the ENTER key
L
is pressed and held down, and
the PLAY key is pressed at the same time, a “cross
play” function is enabled where the deck whose
PLAY key is not pressed will stop playback, and the
deck whose PLAY key has been pressed will start
playback.
F JOG dial
Use this to advance or retard the playback position at
a maximum resolution of 1 frame. The resolution can
be set using the procedure described in 3.3.3, “Cue-
ing using the JOG dial”.
This dial is also used for setting parameter values,
etc. as explained elsewhere in this manual (3, “Basic
operations” and 4, “Advanced Operations”).
G Number keys and CLEAR key
Use these number keys for direct entry of numerical
values such as direct track search, time search, preset
function recall, memory storage, etc.
Use the CLEAR key to reset numeric values.
When the CLEAR key is pressed and held down and
the 0 key is pressed, the number keys take on special
functions, as explained in 4.6, “Number key modes”.
H BANK key
Use to select between the five memory banks.
I PRESET key
Allows the recall of preset functions (see 4,
“Advanced Operations”).
J MEMORY key
Memorizes the current settings.
K RECALL key
Recalls the memories.
L ENTER key
Confirms memory numbers, recall of memories and
preset function settings.
M BPM counter
Shows the tempo (in bpm—beats per minute—from
81 to 161) of the current track, or of the tapped
tempo input with the
TAP key
N
(see 4.5, “BPM”).
N TAP key
Set the tempo in bpm manually by tapping the TAP
key.
When you press this TAP key, the BPM counter
M
mode changes to the TAP mode and the TAP LED (to
the left of the BPM counter) lights.
You can then adjust the tempo later using the dial
F
.
Pressing and holding this key for more than 2 sec-
onds resets the value.
Pressing and holding this key and the BPM key
together allows the value to be adjusted using the
dial.
O BPM key
Selects either the automatic or tap BPM counter
mode.
Clear the tempo by pressing and holding down this
key for more than 2 seconds.
P TEMPO SYNC key
Turns the tempo sync function on and off. When this
function is on, the key lights up. The tempo sync
function allows the playback tempo of the two decks
to be synchronized (see 4.7, “Tempo Sync”).
Pressing this key will adjust the tempo of the deck to
the tempo of the material being played on the other
deck.
While the deck is “locking up”, the TEMPO SYNC
key flashes, and when the sync is locked, the light
lights steadily.
Q BEAT SYNC key
Turns the beat sync function on and off. The beat
sync function synchronizes the playback of the
decks, so that the beats in the material are synchro-
nized with the beats in the material played back by
the other deck (see 4.8, “Beat Sync”).
While the deck is “locking up”, the BEAT SYNC key
flashes, and when the sync is locked, the light lights
steadily.
R LOOP key
Switches looping on and off. When looping is
enabled, the key lights and the display indicator also
lights.