Tascam CD-302 - Manual (Page 14)

2 • Front and rear panels—Remote control unit (rear)
14
TASCAM CD-302
S A and B keys
Use the A and B keys to set, edit and recall the start
and end points of the loop, respectively.
When you have set a loop (start and end points have
been set), the
A and B keys will light.
T SAMPLE key
This key lights when sample playback takes place
and flashes when sample recording takes place.
Press and hold this key and press the IN key to enter
reverse sample playback mode, and press and hold
this key and press the
OUT key to enter loop sample
playback mode.
U IN/OUT keys
Use these keys to set and clear the start and end
points of the sampled sound and edit the end point.
When you have set these points, these keys will light.
Start and stop sample playback using these keys.
V SCRATCH key
Turns the scratch play mode on and off. When this
scratch mode is active, the indicator lights (see 4.9,
“Scratch”).
When the indicator is lit, the playback can be
“scratched” using the dial.
W BRAKE key
Turns the brake mode on and off (see 4.14, “Brake
function”). When the brake mode is active, the indi-
cator lights.
X + and – keys
Changes the key.
These keys have no effect in Original Key mode.
Y KEY ORIGINAL/RESET key
Use to choose between the Original Key mode and
and the Pitch Control mode (where the tempo or the
key may be changed independently of each other).
Z TEMPO 8%/16%/32% key
Selects the maximum amount by which you can
change the tempo and key (“width”).
Repeated presses of this key cycle between 8%
→
16%
→
32%
→
0.0%
→
8%
.
The width is briefly shown in the display for a few
seconds each time it is changed.
a TEMPO slider
Changes the tempo when playing back a disc.
The center position is the normal tempo.
Push the slider up to the – position to decrease the
tempo to the minimum set by the TEMPO key
Z
,
and push it down to the + position to increase the
tempo to the maximum value allowed.
2.4 Remote control unit (rear)
b REMOTE connectors
Connect these to the REMOTE connectors on the rear
of the main unit
5
.