Toshiba e-STUDIO161 - Manual (Page 57)

TROUBLESHOOTING
51
5
C. Misfeed in the transport area
1 Open the fusing paper guide by
pressing down the projection on
either side of the guide and remove
the misfed paper.
Be careful not to tear the
misfed paper during
removal.
2 If the misfed paper cannot be removed
by the previous step but is visible in
the paper output area, remove the
paper by pulling it into the paper
output area.
Be careful not to tear the
misfed paper during
removal.
3 Close the side cover.
The misfeed indicator
(
) will go out.
The fusing unit is hot. Do not touch
the fusing unit when removing
misfed paper. Doing so may cause a
burn or injury.
• When closing the side cover, press on the
handle.
• If the paper was torn, make sure that no
torn pieces remain in the machine.
• If the misfeed indicator ( ) does not
stop blinking, check for torn pieces of
paper in the machine.
Note