Toshiba 2000 - Manual (Page 40)

Chapter 2 Installation
Computer m odule C2PU37 User’s Manual
20
2.6 Connector Connection
Connect each connector to the peripheral device as described below.
CAUTION
• Turn off the power of the main unit and peripheral device when connecting peripheral
devices.
Connecting with the power on may cause injury or burn.
• Be sure to hold the connector when attaching/removing signal cables.
Otherwise, the cable may be damaged causing fire or electrocution.
Important
• Check the shape of the connector and insert the cable properly into the main unit.
The pins may break or bend if unnecessary force is applied.
• If the cable connector is equipped with fastening screws, tighten them so that the
cable does not come loose.
(1) Check that the switch of the power module is in the OFF position.
(2) Connect the cable of each peripheral device to the main unit connector.
After connecting, tighten two screws and fasten the connector to the module.
Match the connectors properly when connecting and connect firmly.