Toshiba 2000 - Manual (Page 28)

Chapter 1 Before turn on the Power
Computer module C2PU37 User’s Manual
8
1.5 Precautions when using
1.5.1 Daily use
Observe the following insturctions during daily use of this equipment.
WARNING
• Turn off the power if there is smoke, unusual odor, excessive heat, or damage.
• Do not block the ventilation port.
If the ventilation ports are blocked, heat cannot escape and fire may occur due to
overheating. When there is a need for repair, contact the Toshiba service desk.
• Do not touch the C2 module when the power is on. The heat radiating side covers
become extremely hot (ambient temperature+25
o
C) when power is on. It cools
(ambient temperture+10
o
C) in 10 minutes when the power is turned off.
1.5.2 When turning Off the Power
Important
• After turning off the power, wait at least 5 seconds before turning on the power.
Faulty operation may occur if you do not wait 5 seconds.
• If an application program is running, quit the program to return to the operating
system (OS).
See
• "Description manual of each application program"
1.5.3 About the Hard Disk Drive
Important
• Do not apply shock or vibration to the equipment when the power is on.
The read/write head of the hard disk drive is at a data area even when the HDD
lamp is off.
• Wait at least 30 seconds after turning off the power before moving the equipment.
The read/write head of the hard disk drive retracts automatically when the
equipment power is turned off. However, it takes approximately 30 seconds for the
hard disk to stop rotating.
The shock may damage the data area.
• Always turn off the power before removing/installing the hard disk drive.
Failure to do so can cause malfunction of the drive.