Tyco 4100U-S1 - Manual (Page 19)

2-1
This chapter describes how to mount the 4100U-S1 cabinet to a wall, and how to mount
system card bays into the cabinets, modules to bays, etc.
Most of a 4100U-S1 is already assembled within the factory. Steps 2 to 6 below are
therefore not typically required in the field, but are included for reference.
The assembly drawings are included in the appendix of this manual for reference.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Introduction to 4100U-S1 Cabinet 2-2
Step 1. Mounting Cabinets 2-9
Step 2. Mounting Card Bays to Cabinets 2-9
Step 3. Configuring Cards 2-9
Step 4. Interconnecting Modules and Bays 2-11
Step 5. Installing Modules into Expansion Bays 2-13
Step 6. Installing LED/Switch Modules into Expansion Bays 2-17
4100U Fan Control Module 2-22
Chapter 2
Installing 4100U-S1 Components
Introduction
In this Chapter