Tyco 4100U-S1 - Manual (Page 123)

F-1
This appendix describes the following:
• Devices that have been approved as compatible devices for use with the 4100U-S1.
• Devices approved for use with the IDNet and shows the number allowed per loop.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
List of Approved Devices F-1
Compatible Detectors, IDNET
F-4
Compatible Addressable Field Devices, IDNet F-5
Simplex Range - Conventional Detectors
4098-9413 Heat detector Type A
4098-9414 Heat detector Type B
4098-9415 Heat detector Type C
4098-9416 Heat detector Type D
2098-9201 Photoelectric smoke detector
2098-9576 Ionisation smoke detector
4098-9618EA Heat detector Type A
4098-9619EA Heat detector Type B
4098-9621EA Heat detector Type D
4098-9621A Heat detector Type C
4098-9601EA Photoelectric smoke detector
4098-9603EA Ionisation smoke detector
Tyco Range - Conventional Detectors
Detector Type 4090-9101
Monitor ZAM
4100-5001/2/4
8 Zone Module
2190-9156
Monitor ZAM
614CH CO/Heat Detector 25 37 25
614I Ionisation Detector 29 40 29
614P Photo-electric Detector 19 28 19
614T Heat Detectors -
Type A, B, C, D
20 30 20
T614
Mk2 Heat Detectors –
Type A, B, C, D 20 30 20
System Sensor Range - Conventional Detectors
Detector Type 4100-5001/2/4
8 Zone Module
2190-9156
Monitor ZAM
4090-9101
Monitor ZAM
885WP-B Weatherproof Heat
Detector Type B @
40 40 40
@ Remote indicator output cannot be wired in common with Tyco 614 series
or the Minerva M614 series (and most other Tyco/Olsen) detectors.
Continued on next page
Appendix F
Compatible Actuating Devices
Introduction
In this Chapter
List of Approved Devices