3 general use, General use – TANDBERG 1500MXP User Manual
Page 28
3 General Use
Wake up the system
When the system is not in use, it is in standby mode and the screen is black. Wake up the system
by picking up the remote control. An incoming call or pressing any key on the remote control will
also wake up the system.
If the system does not respond:
Make sure that the system is switched on by using the On/Off switch located at the rear
of the Codec.
Verify that your monitor is switched on. This is done by pushing the power button on the
front of the monitor, the button on the far right.