TANDBERG 1500MXP - Manual (Page 120)

TANDBERG 1500 MXP
108
4.1.7 Permissions
Permissions contains settings for incoming MCU Calls, incoming telephone Calls, Far End
Control, Remote Software Upgrade and Fallback to Telephony.
Access Code
An access code will help you control the use of the system. All users must enter a code to identify
themselves and the call will be charged on their account. Access Codes are handy for group
systems where there are more users or divisions that share the costs of using the system. Access
Code can be set to "On" and "Off". Please refer to section
Appendix 5 for more information on
Access codes.
On
When making a call, an Access Code dialog box will be shown. The user must enter
the correct password in order to put the call through.
Off No password is necessary to make a call.
Incoming MCU Calls
On
When you are in a call, the system will provide visual and audible indications of an
incoming call and ask you to accept/reject the call.
Off The system will not accept incoming calls when you are in a call.
Incoming Telephone Calls
On
The system will accept incoming telephone calls.
Off The system will not accept incoming telephone calls. This is useful to prevent
incoming calls from systems other than videoconferencing systems.