TANDBERG 1500MXP - Manual (Page 186)

TANDBERG 1500 MXP
174
4.8.2.1 IP Settings
Remember to restart the system after making changes to IP Settings. This can be done by
selecting the “Save and Restart” at the bottom of the IP setting menu. Changes in IP Settings
menu will not have any effect until the system is restarted.
IP Protocol
IPv4
IP version 4 supported.
IPv6
IP version 6 supported. IP Address, IP Subnet Mask and Gateway will be disabled.
Both Both IP version 4 and IP version 6 supported.
IP-assignment
DHCP (Dynamic Host Configuration Protocol) can be selected when a DHCP server is present.
Note that for IPv6, DHCP is used for NTP / DNS Server Addresses.
DHCP
IP-address, IP-subnet mask and Gateway are not used because the DHCP server
assigns these parameters.
Static The system’s IP-address, IP-subnet mask and Gateway must be specified in the IP-
address field.
IP-address
IP-address defines the network address of the codec. This address is only used in static mode. In
DHCP-mode, the assigned IP-address can be found on the Welcome Menu.
IP-subnet mask
IP-subnet mask defines the type of network. This address is only used in static mode. Your LAN-
administrator will provide the correct value for this field.
Gateway
When using DHCP, the default gateway will be set automatically. If the LAN utilizes static IP
addresses, IP address, subnet mask, and default gateway must be specified by the LAN
administrator.