TechniSat DigiPal 2 - Manual (Page 41)

> When you have completed configuring the programme
list according to your preference, press
Menu to
return to normal operation.
> To lift the blocking of individual programmes, proceed
as described above. Mark the specific programme,
and press the
yellow function key to remove the
Parental Control symbol.
8.4 Programme search (scan)
To receive new programmes, several options exist to carry
out a programme search.
1. Automatic search
Select this type of search to scan the entire reception fre-
quency band of the receiver for programmes.
2. Expanded search
Select this type of search to scan a specific frequency or
channel range for programmes.
3. Manual search
Select this type of scan to scan a particular channel or fre-
quency for programmes. Use this type of scan to look for a
specific programme by means of programme-specific PID
numbers.
After the scan has been completed, a message will be
displayed on screen indicating how many programmes your
digital receiver has found, how many of these are new, and
how many are broadcast in encrypted form. New program-
mes will be stored in the
Total list, and can then be trans-
ferred to the Favourites list as described in Point 8.1.
> To perform a programme search, first call up the
Main Menu. (Fig. 8-13)
> Use the arrow keys up/down to mark the entry
Programme Search.
> Confirm by pressing OK.
The sub-menu Programme Search will be display-
ed (Fig. 8-14)
> Now use the arrow keys up/down to select the
type of scan you wish to perform. Confirm by pressing
OK.
8.4.1 Automatic Scan
If this type of scan is selected, the entire reception frequency
range of the receiver will be scanned for programmes.
The scanning procedure may take more than 15 minutes.
Please also note any messages displayed on the screen.
>
You can terminate the scan by pressing the red func-
tion key.
41
(Fig. 8-13)
(Fig. 8-14)
Bedanl DigiPal2_DigitMod T1engl 15.06.2005 16:33 Uhr Seite 41