TechniSat DigiPal 2 - Manual (Page 28)

7.14.7.3 SFI Timer programming
Use the electronic programme guide SFI to simplify the pro-
gramming of timer events.
Marking a programme
> Use the arrow keys or function keys to mark the
appropriate programme
> Press OK to automatically mark the programme, the
receiver will switch to this channel when the program-
me begins.
or
Recording a programme (timer operation)
> Use the arrow keys to mark the desired program-
me.
> Press the OK key twice to highlight the line in red and
to accept the data for this programme directly into the
timer memory.
or
>
Press the red function key (Timer/VCR) to open a
selection window.
> Use the arrow keys up/down to mark your desired
type of timer.
> Confirm by pressing OK.
The timer menu showing the data of the selected
programme will be displayed for monitoring purposes.
If necessary, you can make alterations or corrections
at this stage (see 7.15).
> Press Back to return to the previous table.
The appropriate line will be highlighted. Your receiver
will be switched on at the starting time of the program-
me selected.Most of the functions of the remote con-
trol are disabled at this stage to avoid any accidental
interruption of the recording.
In standby mode the active timer will be indicated by
the blinking of the colon in the time display.
Delete timer operation
If you wish to delete a timer event programmed by means of
the SFI, proceed as described in Point 7.15. To abort an acti-
ve timer, switch the digital receiver off by pressing the
On/Standby key.
Then press this key again to switch the receiver on, and pro-
ceed to operate it normally.
7.14.7.4 SFI Programme overview
The SFI programme overview function allows you to display
the full daily programme of an individual channel. Proceed as
follows:
>
Press the key SFI.
The SFI table “ Now” will be displayed.
28
Bedanl DigiPal2_DigitMod T1engl 15.06.2005 16:33 Uhr Seite 28