Toshiba TECRA S1 - Manual (Page 167)

4.2 Cooling Module 4 Replacement Procedures
TECRA S1 Maintenance Manual 4-19
Installing the Cooling Module
Install the cooling module according to the following procedures and Figures 4-7, 4-8 and .
CAUTION: When installing the cooling module, keep the following in mind:
1. Be sure to confirm the correct position for the module.
2. Route the cooling module cable between the module and MDC card.
3. Please according to the number sequence sealed on heatsink module and secure the
relevant screws on the mainboard.
NOTE: Apply silicon greases with a special syringe to cover the surface of the CPU chip
completely.
CPU chip
Figure 4-8 Applying silicon greases