Tyan Computer Transport GS10 B2094T15 - Manual (Page 25)

25
http://www.TYAN.com
For Windows
1. Press the button according to the number of times specified on the following table, and
you will see the corresponding prompt.
KEY PRESS PROMPT FUNCTION
once (1)
NIC1 IPADDR
Change? Enter the IP address assigned to NIC1
twice (2)
NIC1 NETMASK
Change? Enter the netmask of your network to NIC1
thrice (3)
NIC1 GATEWAY
Change? Enter IP address of the gateway for your network
four (4) times
NIC1 DNS1
Change? Enter the primary DNS address assigned to the
NIC1
five (5) times
NIC1 DNS2
Change? Enter the secondary DNS address assigned to the
NIC1
six (6) times
Reboot
Server? Allows you to reboot the server
seven (7) times
Shutdown
Server? Allows you to shutdown the server
eight (8) times
NIC2 IPADDR
Change? Enter IP address assigned to the NIC2
nine (9) times
NIC2 NETMASK
Change? Enter netmask address assigned to the NIC2
ten (10) times
NIC2 GATEWAY
Change? Enter gateway address assigned to the NIC2
eleven (11) times
NIC2 DNS1
Change? Enter primary DNS address assigned to the NIC2
twelve (12) times
NIC2 DNS2
Change? Enter secondary DNS address assigned to the NIC2
2. Press the button to confirm selection of the option displayed.
3. Use the button to increase or button to decrease the value.
4. Then, press the button to accept the data entered and return to the main screen.
NOTE: If you press the button to cancel the configuration, you must go through the
entry process again.