Tyan Computer Transport GS10 B2094T15 - Manual (Page 24)

24
http://www.TYAN.com
Setting the Configuration
For Linux
1. Press the button according to the number of times specified on the following table, and
you will see the corresponding prompt .
KEY PRESS PROMPT FUNCTION
once (1)
NIC1 IPADDR
Change? Enter the IP address assigned to NIC 1 (Network
Interface Card)
twice (2)
NIC1 NETMASK
Change? Enter the netmask of NIC 1
thrice (3)
NIC2 IPADDR
Change ? Enter the IP address assigned to NIC 2
four (4) times
NIC2 NETMASK
Change ? Enter the netmask of NIC 2
five (5) times
Default GW
Change ? Enter IP address of the gateway for your network
six (6) times
Primary DNS
Change ? Enter IP address of the primary DNS for your network
seven (7) times
Secondary DNS
Change ? Enter IP address of the secondary DNS for your
network
eight (8) times
Reboot
Server ? Allows you to reboot the server
nine (9) times
Shutdown
Server ? Allows you to shutdown the server
2. Press the button to confirm selection of the option displayed.
3. Use the button to increase or button to decrease the value.
4. Then, press the button to accept the data entered and return to the main screen.
NOTE: Please restart the LCD driver under Linux when you change the NIC settings from
Static to DHCP by running “killall LCDdaemon”, and then running
/LCD/LCDdaemon.