TurboChef Technologies Residential Single and Double Wall Oven User Manual
Page 21
SPECIFICA
TIONS
AND
INST
ALLA
TION
1.5
Installing the Oven
CAUTION: Before installing the oven, verify
voltage at the wall receptacle matches the voltage
specifi ed on the oven’s rating plate (located behind
the Speedcook oven door). Each oven is voltage
specifi c and will not function properly if supply
voltage is diff erent than intended voltage.
1. Ensure power is disconnected at the breaker.
2. Remove oven from box/crate and place on a
level
surface.
NOTE: Th
e oven is shipped with two support rails
attached to the bottom. Th
ese rails allow the oven
to sit level and keep the bottom of the frame from
being damaged during installation. To properly place
the oven into the cabinets, these support rails must
be removed.
3. Remove all packing materials.
4. Verify the cabinet is built to the proper
specifi cations.
5. If provided, install the base slide plate (Figure
1.5,
below).
Th
is plate will make installation
and future servicing of the oven easier.
Double Wall Oven Cabinet Dimensions
Cabinet
Width (min): 30” (762 mm)
Wood Fascia Th
ickness (min): ⅜” (10 mm)
Rough Wall Opening
Height (min/max): 48⅞” (1241 mm)
Width (min/max): 28½” (726 mm)
Upper Corner Radius (preferred): ½” (13 mm)
Depth (min): 24” (610 mm)
Cabinet Base Height
Wall Installations (min): 11” (279 mm)
Wall Installations (max): 15” (381 mm)
NOTE: Failure to adhere to the rough wall opening
specs may cause corners of the cabinet opening to be
exposed.
Single Wall Oven Cabinet Dimensions
Cabinet
Width (min): 30” (762 mm)
Wood Fascia Th
ickness (min): ⅜” (10 mm)
Rough Wall Opening
Height (min/max): 25⅛” (638 mm)
Width (min/max): 28½” (726 mm)
Upper Corner Radius (preferred): ½” (13 mm)
Depth (min): 24” (610 mm)
Cabinet Base Height
Wall Installations (min): 34¾” (883 mm)
Wall Installations (max): 38¾” (984 mm)
Under Counter Installations (min): 5½” (139 mm)
NOTE: Failure to adhere to the rough wall opening
specifi cations may cause corners of the cabinet open-
ing to be exposed.
.
.
.
Figure 1.5: Base Slide Plate Installation