TurboChef Technologies Residential Single and Double Wall Oven - Manual (Page 17)

SPECIFICA
TIONS
AND
INST
ALLA
TION
1.1
Theory of Operation
Th e TurboChef
®
Residential Speedcook oven
combines high-speed forced air impingement and
microwave energy to cook food up to 15 times faster
than a conventional oven. Th
e re-circulating air
transfers heat to the food and then passes through
a catalytic converter where excess grease and odors
are removed and combusted. Simultaneously, precise
bursts of microwave energy cook the food from the
inside out. Th
is combination of heating technologies
quickly cooks food and seals moisture to help ensure
chef-quality results in a fraction of the time.
Th is manual includes instructions for servicing,
troubleshooting, installing, cleaning, and operating
the TurboChef Residential double and single wall
ovens. If you have questions not addressed in this
manual, contact Technical Service (866.447.3783,
+1 214-379-6000) or your Authorized Distributor.
Catalytic Converter
Th e catalytic converter removes odors and grease
from the air inside the cook cavity. It is also
responsible for limiting and removing any smoke
from the cavity in case of a spill. Do not use oven
cleaner when cleaning the Speedcook oven, as the
catalyst can become damaged by the use of caustic
cleaners, resulting in a non-warranty service call.
See pages 2.10, and 3.4 for approved self-cleaning
instructions.
Certifi cations
cETLus
Electrical Specifi cations
Phase: Single
Frequency: 60 Hz
Current: 50 amp (DWO) / 30 amp (SWO)
Cord: 4-wire (inc. ground)
Voltage: 208 or 240 (depending on model)
Connection: 5½ ft fl ex conduit
Total Connected Power: 50 amp (DWO) / 30 amp
(SWO)
NOTE: Unit includes a 5½-ft fl ex conduit to be
used between the oven and conduit box. Connectors
are supplied by the installation electrician.
NOTE: Branch circuit MUST be protected with a
50-amp (Double Wall Oven) or 30-amp (Single Wall
Oven) over-current protector.
CAUTION: If there is a high leg in supply
voltage, ensure it is not on L2. Having it present on
L2 will damage critical 120V oven components.