TurboChef Technologies Residential Single and Double Wall Oven - Manual (Page 112)

A.20 APPENDIX - REPLACING OVEN COMPONENTS
Item Description Item Part # Hardware Description Hardware Part Number(s)
Capacitor, H.V. 100213
Bracket, Capacitor
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Screw, #6-32 x 1/2 LG, PPH, SS
Nut, #6-32, Serr Hex FLNG, SS 104197
101688 (x2)
101570
100902
Diode, H.V. 100481 Screw, #8 x 1/2, PHPH, PLT 101689 (x2)
Relay, K9 104179 Screw, #6 x 1/2, PPHD, DRL-PT, SS 101687 (x2)
Thermostat, 140F, Close on Rise 102087 Screw, #6 x 1/2, PPHD, DRL-PH, SS 101687 (x2)
Capacitor, H.V.
Diode, H.V.
Thermostat, 140F, Close on Rise
Figure A.14: Mag Air Diverter Assembly Detail, DWO Gen 2 and SWO
Capacitor, H.V.
Relay, K9
Diode, H.V.
Thermostat, 140F, Close on Rise
Figure A.13: Mag Air Diverter Assembly Detail, DWO Gen 1
Mag Air Diverter Assembly Detail, DWO Gen 1, DWO Gen 2, and SWO
DANGER: Before removing or replacing any oven component, ensure the oven is removed from any
power source (i.e., the breaker is turned off ). Failure to do so can result in serious injury or death.
WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions
found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the wire
harness (where applicable).