Component and assembly location, swo, A.8 appendix - replacing oven components, Removing the oven – TurboChef Technologies Residential Single and Double Wall Oven User Manual
Page 100
A.8
APPENDIX - REPLACING OVEN COMPONENTS
Component and Assembly Location, SWO
DANGER: Before removing or replacing any oven component, ensure the oven is removed from any
power source (i.e., the breaker is turned off ). Failure to do so can result in serious injury or death.
WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions
found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the wire
harness (where applicable).
Removing the Oven
In order to remove the oven from the wall, the two mounting screws (P/N: 104184), located on the inside of
the Speedcook oven’s outer trim, must be removed. Th
e oven may be safely pulled away from the wall
approximately 11” (280 mm) to remove the front top cover, lower EC access panel, and the door switch
covers. Any further removal requires the oven to be fully removed from the wall and placed upon a cart
capable of supporting approximately 230 lbs. (105 kg.).
Item Description
Item Part # Hardware Description
Hardware Part Number(s)
Air Switch
102009
Screw, 4-40 x 5/8, PPH, SS
101550 (x2)
Blower, Exhaust
104190
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
101688 (x2)
Cover, Back, SWO
RWS-9018
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
101688 (x11)
Door Skin, Replacement
RWD-3004-X
None
None
Door, Speedcook Oven
RWD-3019-X
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Cover, Hinge Pocket
Screw, #8-32 x 3/8, PPH, THD-Forming, PLT
101688 (x4)
RWD-9472 (x2)
104227 (x2)
Door, Speedcook Oven, Inner
RWD-3022
None
None
Electrical Compartment, SWO
(see pages A.16-A.17)
N/A
None
None
Front Trim, SWO
(see pages A.10-A.11)
N/A
Screw, #8 x 3/8 PH MOD TRUSS CRES
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Screw, #8 x 2.00 PH MOD TRUSS SS
101682 (x16)
101688 (x4)
104184 (x2)
Handle, Speedcook Oven
RWD-9011
Bolt, Handle, Speedcook Oven
RWD-9458 (x2)
Harness, Single
RWS-9002
None
None
Oven, Speedcook, SWO
(see pages -A.25)
N/A
None
None
Thermostat, 270F, Open on Rise
104228
Screw, #6 x 1/2, PPHD, DRL-PT, SS
101687 (x2)
Top Cover, Front
RWD-9356
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
101688 (x7)
Top Cover, Rear
RWD-9355
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
101688 (x11)
USB Port, Gen 2
103193
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Bracket, USB, Strap
101688 (x2)
RWS-9026