beautypg.com

Nic card jumper settings, Wired media card jumper settings, Nic card jumper settings -8 – Tyco 4100U User Manual

Page 88: Wired media card jumper settings -8, Step 1. configuring network cards, Continued

background image

5-8


There are two shunt jumper ports on the NIC card that need to be set: P3 and P4.

P3: Determines the NIC data transmission rate, 57.6 kbits/second or 9600 bits/second.
• Position 1 – 2 (the right two pins) or no pins jumpered: 57.6 kbits/second.

• Position 2 – 3 (the left two pins): 9600 bits/second.

P4: Determines the data protocol, 8-bit or 9-bit, that the NIC card is using.
• Position 1 – 2 (the right two pins) or no pins jumpered: 9-bit.

• Position 2 – 3 (the left two pins): 8-bit.

All settings are labeled on the card.

P2: Tells the system which wire type is to be used.
• Positions 1 – 2, 5 – 6, and 7 – 8: 18 AWG shielded, twisted pair wiring.

• Remove all jumpers to specify 24 AWG twisted pair telephone cable wiring.

IMPORTANT: When using the wired media card, the Earth fault detection is

performed on the left port only. Remove R1 (1 Ohm resistor)
from the media card on the right port.

Step 1. Configuring Network Cards,

Continued

NIC Card
Jumper Settings

Wired Media Card
Jumper Settings