Toshiba TDP-PX10 - Manual (Page 31)

31
Operations
Using handy features
Using auto setting (For computer input only)
This function automatically sets up the projector to the optimum state. It sets
up sampling phase, frequency and screen position, for each type of the
input signal by using simple operations.
„ Press the AUTO SET button on the remote control.
For computer input, the icon will appear during processing.
Note
• The image may not be projected or auto adjustment/setting may not be performed
correctly for input signals other than those supported by the projector , /
• If auto setting fails adjustment, adjust manually with Image adjustment menu /
Correcting the keystone distortion
When the projector placement angle against the screen is changed while
projecting the image, the picture will undergo keystone (trapezoidal)
distortion. This projector can correct for this keystone distortion.
„ Press the remote control’s KEYSTONE + / - button.
You can also select [ Keystone ] in the Image adjustment menu .
Note
• Depending on the amount of keystone adjustment and the content of images, some
information may be lost, or the picture quality may suffer.
Cutting off the picture and sound temporarily (Mute)
When you want to project the images of another projector, overhead
projector, etc. temporarily, this projector’s images and sound can be turned
off.
„ Press the remote control’s MUTE button.
The picture and sound are cut off. (The Mute function is released when
pressing the
MUTE button again.)
Note
• The icon will appear while mute is in effect.
• Operating any other functions will also cancel the muting.
Remote Control
p.49 p.50
p.34
Remote Control
Before correctIon After correctio n
p.34
Remote Control