Toshiba TDP-PX10 - Manual (Page 28)

28
Operations Turning the power on and off
„ Connecting the power cord
Insert the power cord connector into the AC IN
socket of the projector.
Insert the power cord plug into a wall or other
power outlet.
The TEMP, ON/STANDBY and LAMP indicator will flash,
and then ON/STANBY will only remain flashing, indicating
standby mode.
„ Removing the lens cover
Be sure to remove the lens cover when the power is turned on.
If the cover is left on the projector, it could become deformed
due to heat.
„ Turning the power on
Press the ON/STANDBY button.
The power turns on and the ON/STANDBY
indicator lights. After a moment, the start-up
screen appears.
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may
cause damage to your eyesight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal
overheating.
• Do not place your hands, face, or other objects near the air exhaust, the lamp
cover or the bottom of the unit.
Doing so could result in injury and/or damage the
object.
Control panel
Remote
Control Start-up screen