Texas Instruments 6100 - Manual (Page 56)

Installing a DockMate Docking Solution
4-6 Setting Up Your Desktop
adapters to fit the connectors on the DockMate.
• Serial cables with 25-pin connectors require
an adapter to fit a 9-pin connector
• Older keyboards require an adapter to fit a
PS/2 port
Many connectors have screws attached to
secure the connection. If you want to secure the
connectors to the DockMate, you might need a
small screwdriver.
Installation
procedure To connect your computer to a DockMate
Docking Solution, follow these steps.
Note: You might find it easier to connect all of
the external accessories to the DockMate before
docking the computer.
1. Turn off the computer.
2. Open the access door on the back of the
computer.
3. Lift the latch on the DockMate.
4. Lower the back of the computer onto the
pegs on the DockMate.
5. Close the latch.
6. Follow the installation procedure
accompanying your DockMate model to
complete the installation.
pegs
latch
eug-4.frm Page 6 Saturday, January 25, 1997 10:32 AM