Texas Instruments 6100 - Manual (Page 42)

Installing Memory Modules
3-8 Installing Internal Accessories
1. From the Taskbar, select Start then Shut
Down.
2. Select Restart the Computer in MS-DOS
mode.
3. Click on Yes.
4. Type PHDISK /D /F at the DOS prompt
and press Enter.
The Save to Disk partition is deleted.
5. Press any key to reset the system.
The computer restarts.
6. From the Taskbar, select Start then Shut
Down.
7. Select Restart the Computer in MS-DOS
mode.
8. Type PHDISK /C /F and press Enter.
The Save to Disk file and partition are
created. You are prompted to press any key
to reset the computer.
9. Press any key to reset.
In Windows for Workgroups
Follow these steps if your computer is running
MS-DOS and Windows for Workgroups.
1. Close all applications and exit Windows for
Workgroups to MS-DOS.
2. At the command prompt (typically C:\) type
PHDISK /D /F and press Enter.
The Save to Disk partition is deleted.
3. Press any key to reset the system.
The computer restarts.
eug-3.frm Page 8 Thursday, January 23, 1997 3:26 PM