Table 4-1 – Tandberg Data SDLT 600 User Manual
Page 55
SDLT 600 Product Manual
Chapter 4: Installing Your Tape Drive
81-81184-02 REV A01
March 2004
4-7
N
OTE
: The computer system and the tape drive SCSI IDs are only checked at
power-on. To change the SCSI ID after installation, power off both the
system and the tape drive, change the tape drive’s SCSI ID, power on the
tape drive, and then power on the system.
Figure 4-2.
10-pin SCSI ID Jumper Block on Rear of Tape Drive
Table 4-1.
SCSI ID Address Selections (Graphical Format)
SCSI ID
Jumper Block
0
1
2
3
SCSI ID
Jumper Block
4
5 (default)
6
7
SCSI ID
Jumper Block
8
9
10
11
SCSI ID
Jumper Block
12
13
14
15
SCSI ID Jumper Block
(No jumpers on this block
selects default SCSI ID of 5)