A.5 loading a data cartridge, Loading a data cartridge – Tandberg Data SDLT 600 User Manual
Page 101
SDLT 600 Product Manual
Appendix A: Super DLTtape I and Super DLTtape II Data Cartridges
81-81184-02 REV A01
March 2004
A-9
A.5 Loading a Data Cartridge
Complete this subsection to load a data cartridge into the front of the tape drive; refer to
needed.
1.
Insert the data cartridge into the front of the tape drive, as shown in
.
2.
Push the data cartridge fully into the tape drive.
The Drive Status LED flashes to show that the media is loading. When the media reaches the
Beginning of Tape (BOT) marker, the LED lights steadily. The data cartridge is now ready for use.
Figure A-7.
Loading a Super DLTtape II Data Cartridge
Drive Status LED
Eject Button
Data Cartridge
Tape Drive