TurboChef Technologies 3240 User Manual

Page 11

INST

ALLA

TION

Lower Cover Upper Cover

STEP 5: INSTALL THE COMPONENTS

5.1

Remove the lifting brackets from the oven(s).

5.2

Immediately discard the lifting brackets and lifting-bracket bolts.

5.3

Install the supplied screws (refer to page 2).

5.4

Replace the burner compartment cover(s).

5.5

Install the bottom covers on the oven(s). A left and right

bottom cover is supplied. Each bottom cover is specifi c to

the left and right sides of the oven(s).

5.6

Install the upper covers on the oven(s). A left and right

upper cover is supplied. Each top cover is specifi c to the

left and right sides of the oven(s).

5.7

Install the conveyor belt assembly on the oven. The

conveyor belt assembly can only be installed from the right

side of the oven.

5.8

Maneuver the conveyor into position by lifting both ends

and moving it slightly back and forth until it catches in

place. Once the conveyor is in place, you should not be

able to move it unless you lift the ends.

5.9

Attach the conveyor drive chain.

NOTE:

Repeat STEPS 5.1-5.9 for the middle and top oven if double or triple-

stacking ovens.

5.10

Attach the crumb tray holders to each end of the conveyor(s).

5.11

Install both crumb trays by sliding them into place underneath the ends of the

conveyor(s).

Step 5.1

Step 5.3

Step 5.5-5.6

Step 5.7

Step 5.10